101工业级吊牌枪： 全系配套总共3个钢针头

针头：针头全长3.5厘米

搭配：套餐配套5000发胶针  适合于 速卖通 亚马逊 销售。

Tagging Gun
标签枪

Tag Fasteners Installation
紧固件的安装
Step 1:Grip the gun handle
第一步：握紧枪柄
Step 2: Insert either end of the tag pin connecting bar (T letter port) into the hole at top of the gun, push the pin into the slot as far as it will go on
步骤2：将标签销连接杆（T字母端口）的任一端插入枪顶部的孔中，将销尽可能地推入槽中。
Step 3: Release the handle,finish and begin use
步骤3：松开手柄，完成并开始使用
Needle Installation
打捆针安装
Step 1: Set the white switch to 3 o'clock
步骤1：将白色开关设置为3点钟
Step 2: Keep the needle slot and gun slot on the same horizontal line and insert
第二步：将针槽和枪槽保持在同一水平线上并插入
Step 3:Set the white switch to 9 o'clock finish and begin to use
步骤3：将白色开关设置为9点钟结束并开始使用
Attantion:
注意：
1.When not use,protect the needle by the covering cap.
1.不使用时，用盖帽保护针。
2.Before taking out the tag pin,please grip the gun handle firstly,then take it out.Otherwise,it may damage the fittings in the gun
2.在取出标签销之前，请先抓住枪柄，然后取出，否则会损坏枪内配件